講解關于滑觸線操作安全注意事項介紹

(a) on the characteristics of the parallel collector.
由于同相集電器時并聯連接，所以任意時候只要有一個集電器與帶電滑線連接，其它的集電器和與之接觸的物體均處于帶電狀態
Because when the in-phase collector connected in parallel, so any time as long as there is a collector and charged slide wire connection, collector and other objects in contact with are in charged state
（b）典型的錯誤操作有：
(b) typical mistake operation:
因集電小車跨接轉龍段和主龍段，而轉龍段或主龍段的其中一段是處于斷電維修狀態。維修時建議關斷主供電電源并鎖死開關
Because the collector car jumper to the long period and the main long segment, and to the long segment or principal dragon section a section of which is in a power down state of repair. Suggestions off main power supply switch and lock repair
因帶電檢查集電器。
Check for charged collector.
因集電器放錯相
Because the collector is put in the wrong phase
因集電器未正確放入滑觸線
Because the collector is not properly placed in sliding contact line